Tanning Bed Bulbs Not Working

If the tanning bed uses 230vaceuropean ballasts choke there is the remote possibility that a ballast has gone bad.

Tanning bed bulbs not working. There is no power supplied to the bed. There is a loose at the relay. If the tanning bed is new it could be caused by lamp end vibration from shipping see above or a wire from the ballast came loose. You may want to make some short jumper wires and push them into the blade connectors.

Be aware that tanning bulbs contain mercury and other potentially harmful materials. It is also possible that one of the wires has come loose inside the bed. One of the transformers also called ballasts has probably gone bad. This means what you see may not be what you get an extremely important consideration because although very low dose far range uv c light may not harm humans or animals using too powerful a.

The above may be correct and so are you. Then pop the new bulb into place ensuring it s locked in before replacing the next bulb. Two or three lamps in a row quit working. Here is a guide that will be useful for the owner of a residential tanning bed.

If the bed refuses to start or to turn on there could be four possible reasons. There is a bad relay. Or cut the ends off strip them and then wire nut them together. Removing the old bulbs should be as simple as gently popping them out of place being careful not to put too much pressure on the glass.

You should probably call an electrician who has.